Click image to view full size image
Specifications:
- Here at Cidly, we are rigorously implementing the internationalquality control system into our production. We strive to createhealthy lighting and as such, we are constantly ensuring ourproducts are in accordance with the requirements for environmentalprotectionof ROHS and CE directives.Equipped with advancedproduction facilities and production lines,
Description:
Unique innovative ideas:I. Double cages structural heat dissipation design, better coolingperformance
The double cages structural design change the heat dissipation modeof the traditional LED grow light, divide the inside of the lamp totow parts, and form two heat-dissipation cages, cut off theinternal thermal cycle effectively and reach the best coolingperformance.
Use the unique air-out design and open air exhaust in the two sidesof the lamp, remove the high temperature air rapidly, ensure thelight body operation in a low-temperature environment.
II. Prevent drippage water design
The lid of the light is with sloping ends and 5°angled holes toprevent the light from the damaging of drippage and dust.
III. High quality 3W LED+700mAcurrent=The top performance
700 mA is the best drive current for 3W LEDs, runing LEDs withpossibly high current can take full advantage of LEDs, making yourinitial investment in LED devices to be well worth it.However, LEDsand LED drivers should be of superior quality as so to undertakethe high electric current, besides the entire equipment should begood enough in heat dissipating to bear all the heat emitted by 3wleds.Selects the finest LEDs and drivers to ensure the stableperformance as well as the long life span of the fixtures, ourthree-year warranty policy proves our confidence in products.
IV. Modularity design
Modularity design, each part interconnect by the male female plugdirectly, very easy for repairment and maintenance, only few stepsto assemble up the whole fixture.
V. RTPM intelligent control system(Remote, Dimming, Timing andTemperature control)
RTPM is a multifunction intelligent system, including remote,dimming, timing, custom temperature control and mult-unit chainingfunction. In order to meet the growth demand of all kinds plants,the users can choose various different lighting effectscheme.
1.Remote-controlled, dimming and timing
There are three controllable circuits in the light, the brightnessvalue is 0%-100%, in order to add and reduce the adjustablebrightness , 1% or 10% is available, also, 1% is allowed toadjust the brightness in the single circuit. Four time bucket canbe set on brightness in each circuit. In the right system timesetting circumatances, when the time reach timing time bucket, thehole light will turn into the timing preinstall brightnessautomatic., 24 hours continuous cycle.(Please see the remoteoperation instruction manual )
2.Temperature control and protection
When the heat sink temperature over 65℃, theintelligent temperature control will cut off the power supplysystem automatic. The system will outo star when the temperaturecooling to 50°.
3.Data memory
The brightness and timing setting will auto-save aftersetting 45 seconds, the lamp will enter the setting brightnesscondition last time when it electrify and get to work next time.The system time will keep the clock continuous operation about 3months after the lamp completely without electricity, the built-insuperbattery will be full charged within 20 seconds. Also, itwithout needing battery replacements.
Specification
Name: 120W LED Grow Light Actual power: 120W
Model: CDL-G-ZA120W-B LED Qty:60pcs*3W
Input voltage: AC100~240V LED color: Red(630nm)/Blue(460nm)
Output voltage: DC70~90V Lifespan: 50, 000 Hours
Input current: 690mA Brightness value: 0%~100%
Low voltage impulse: 400us PF: 0.9
Control system: RTPM Working frequency: 50~60Hz
Circuits: 2 Working environment: -20~40℃, 45%~95%RH
Product size: 288*280*75mm N.W.: 3.7kg
Inner carton size: 346*346*150mm G.W.(Inner carton ): 4.4kg
Outer carton size: 612*358*362mm/4pcs G.W.(Outer carton ):18.6kg
Standard configuration: LED Light x1, Remote control x1, Power linex1, Chaining x2, Remote control operating instruction x1
Remarks :The above parameter is based on Red:Blue=8:1, forreference only
Illumination and PAR value data sheet
Height(cm) 20 40 60 80 100 150 200
PAR (umol m-2s-l) 2050 750 380 200 130 60 35
Irradiation Area(m^2) 0.2 0.45 0.8 1.35 2 3.5 5.8
(Remarks: the irradiation area is base on PAR value＞10 )
Characteristics:
1. Changed mesh vents to hollow out, increase the air displacementand the cooling capacity per unit time, more convenient forcarrying.
2. Using built-in quiet fans, and use the shutter in the wind,induced draft from all sides, very low noise, waterproof anddustproof, waterproof grade can reach IP32.
3. Special structure make the heat dissipation effect very good,the temperature of the LEDs' feet dropped below 50°, lowest badloss rate of the lamp bead.
4. Use advanced isolation power supply and soft start protectiontechnology, to prevent the high voltage when turn on the light fromdamaging the lamp body.
Introduction:
1. Use high quality LED lighting source, the lifespan is up to50000 hours.
2. Replace 3~5 times of the HPSL power, 80% electric energy savingthan the tradition HPSL and MHL.
3. High lighting effect, 90% of the light will be absorbed by theaquatic plant, but to the traditional HPSL and MHL, the lightingeffect is just 8%~10%.
4. Input cooling system, well solve the heat sink problem.
5. The input voltage is AC100V~240V, suitable for the worldstandard. Built-in power supply. No need other equipment, justaccess AC100~240V voltage from the plug, the lamp will be workingsmoothly, don't need the reflector and ballast either.
6. The lighting area and the height are changeable according todifferent plants and environments, the same as the parameter.
7. Environment-friendly, no mercury and other harmful heavy metal.
8. Customers can choose the different ratios, Our suggestion isred: blue=8:1 or 7:2, red: blue: orange=7:1:1. The suggestedwavelength of the red is 620-630nm, the blue is 460-470nm and theorange is 610-615nm. With the mixture of red , blue, orange,yellow, UV, IR and white lights, provide the plants needed nutrientlight. The red LEDs are good for sprouting and flowering,while the blue LEDs promote the growth, at the same time, customersalso can choose the more suitable wavelength and LED colors.
Application:
Ideal for all phases of plant growth, and works well with watersolution culture and soil culture. Can be used in house garden, potculture, garden, sowing, breeding, farm, flower exhibition, bonsai,garden, green house, sowing, breeding, farm, greenhousecultivation, water soluble breeding, greenhouse cultivation,pipeline cultivation and so on.
Attention:
1. In order to save energy, please turn off the power if not usethe lamp in a long time.
2. Do not use the lights in dripping water or anywhere where theywill get wet, water and electricity can be a dangerous mixture.
3. The working environment for the light is -20~40℃,45%RH~90%RH.
4. To protect the light, Pls cut off the power when there is alightning strike.
5. Don`t touch or move when the light working.
china Noah's Ark led grow lights
